Use and Care Manual
Table Of Contents
- NO TITLE
- NO TITLE
- .
- ? Installing the Upper Handle
- ? Installing the Wheel-Clutch-Cable Ends
- ? Installing the Traction-Control Linkage
- ? Installing the Chute-Control Rod
- ? Connecting the Headlight and Handwarmer Wires to the Engine
- ? Installing the Snow-Cleanout Tool
- ? Checking the Engine-Oil Level
- ? Checking and Adjusting the Tire Pressure
- ? Checking the Skids and Scraper
- ? Checking the Operation of the Traction Drive
- NO TITLE
- NO TITLE
- NO TITLE
- .
- Maintenance Safety
- Preparing for Maintenance
- Checking the Engine-Oil Level
- Checking and Adjusting the Skids and Scraper
- Checking and Adjusting the Traction Cable
- Checking and Adjusting the Auger/Impeller Cable
- Checking the Auger-Gearbox-Oil Level
- Changing the Engine Oil
- Lubricating the Hex Shaft
- Replacing the Spark Plug
- Adjusting the Discharge-Chute Latch
- Replacing the Drive Belts
- Replacing the Headlight Bulb
- NO TITLE
- NO TITLE
Important:Ensurethatthecurvedsideof
thecableclampisagainstthehandleand
thatthecableisroutedbelowtheclampbolt.
Thecablemustbeinastraightlinefromthe
cableclamptothepointwhereitattachesto
thewheel-clutchlever.
4.Pullthecablejacketdowngentlyuntilthe
wheel-clutchleverisdownandtheslackisout
ofthecable,thentightenthecable-clampnut
securely(Figure8).
g001305
Figure8
5.Squeezetheleverfully,thencheckthegap
betweenthebottomofthehandleandtheend
ofthewheel-clutchlever(Figure9).
g001306
Figure9
Note:Thegapshouldbeapproximatelythe
thicknessofapencil(1/4inchor6mm).Ifitis
greater,loosenthecable-clampnut,slidethe
cablejacketupslightly,tightenthecable-clamp
nut,andcheckthegapagain.
6.Repeatsteps2through5fortheothercable.
Installingthe
Traction-ControlLinkage
g220056
6