Service Manual
Table Of Contents
- Revision History
- Preface
- Chapter 1 : Safety
- Chapter 2 : Specifications and Maintenance
- Chapter 3 : Troubleshooting
- Chapter 4 : Engine
- Chapter 5 : Controls
- Chapter 6 : Belts
- Chapter 7 : Auger Housing
- Chapter 8 : Auger Gearbox
- Chapter 9 : Wheel Clutch Traction Drive System
- Chapter 10 : Discharge Chute
- Appendix A: Foldout Drawings
- Electrical Schematic with Hand Warmers
- Electrical Schematic
DeectorCableRemoval(continued)
Figure26
4.Removethecableclamponthetractionhousing.
DeectorCableInstallation
1.Connectthecableendtothedeector.Securewithacableclamp.
2.ConnecttheZ-bendendtothemachine.
3.Installthecableontothebracket.Securewithtabs.
4.Connectthecableclamptothetractionhousing.
DeectorCableAdjustment
MakesuretheQuickStickisinthemaximumrearpositionandcentered;ensure
thedeectorisinthefullupwardposition.Drawtheslackoutofthecableand
securetheclamp.
Figure27
Controls:ServiceandRepairs
Page5–14
POWERMAX®HDServiceManual
3424-820RevA