Service Manual
Table Of Contents
- Revision History
- Preface
- Chapter 1 : Safety
- Chapter 2 : Specifications and Maintenance
- Chapter 3 : Troubleshooting
- Chapter 4 : Engine
- Chapter 5 : Controls
- Chapter 6 : Belts
- Chapter 7 : Auger Housing
- Chapter 8 : Auger Gearbox
- Chapter 9 : Wheel Clutch Traction Drive System
- Chapter 10 : Discharge Chute
- Appendix A: Foldout Drawings
- Electrical Schematic with Hand Warmers
- Electrical Schematic
TractionDriveSystemRemoval(WheelClutchModels)(continued)
Figure63
18.Removethebeltcover.
Figure64
19.Removetheextensionspringfromthehousing.
20.Removethepivotpulleyboltsoneithersideofthehousing.
21.Removethepivotpulleyplateassemblyfromthehousing.
TractionDriveSystemInstallation(WheelClutchModels)
1.Installthepivotplateassemblyontothehousingandinstallthebelt.Theidler
pulleyshouldbepushedawaytoinstallthepivotplate.
2.Installthechainsandpinionontothehexshaft.
Note:Themasterlinkclipshouldbeplacedinthecenteroftheunit.
3.Installthefrictiondiskandhexshaft.
4.Installthehexshaftbearingretainers.
5.The44–toothgearsshouldhavethehubfacinginwardbeforeinstallation.
POWERMAX®HDServiceManual
Page9–11
WheelClutchTractionDriveSystem:ServiceandRepairs
3424-820RevA