Service Manual
Table Of Contents
- Revision History
- Preface
- Chapter 1 : Safety
- Chapter 2 : Specifications and Maintenance
- Chapter 3 : Troubleshooting
- Chapter 4 : Engine
- Chapter 5 : Controls
- Chapter 6 : Belts
- Chapter 7 : Auger Housing
- Chapter 8 : Auger Gearbox
- Chapter 9 : Wheel Clutch Traction Drive System
- Chapter 10 : Discharge Chute
- Appendix A: Foldout Drawings
- Electrical Schematic with Hand Warmers
- Electrical Schematic
TractionDriveSystemReplacement(AutoturnModels)
TractionDriveSystemRemoval(AutoturnModels)
1.Parkthemachineonalevelsurface.Stoptheengine,waitforallmoving
partstostopandremovethekey.
2.Removethefuelfromthemachine.
3.Disconnecttheshiftlinkageandtipthemachineforwardontheauger
housing.
4.Removebothwheelsandwheelkeys.
5.Removetheupperandlowercovers.
6.Removethe2screwssecuringthebearingretainersandhexshafttoeach
sideofthetractionassembly.Removebothbearingretainers.
7.Removethehexshaftandfrictionwheels.
8.Removethe4screws(2perside)securingtheintermediateshafttothe
housing.
9.Removethesnapringsecuringtheaxlebearingtothehousing.
10.Slidetheaxlebearingontothedriveshaft.
Figure66
11.Pulltheaxlethroughthehousing.
POWERMAX®HDServiceManual
Page9–13
WheelClutchTractionDriveSystem:ServiceandRepairs
3424-820RevA