Use and Care Manual
Table Of Contents
- NO TITLE
- NO TITLE
- .
- ? Installing the Upper Handle
- ? Installing the Wheel-Clutch-Cable Ends
- ? Installing the Traction-Control Linkage
- ? Installing the Chute-Control Rod
- ? Connecting the Headlight and Handwarmer Wires to the Engine
- ? Installing the Snow-Cleanout Tool
- ? Checking the Engine-Oil Level
- ? Checking and Adjusting the Tire Pressure
- ? Checking the Skids and Scraper
- ? Checking the Operation of the Traction Drive
- NO TITLE
- NO TITLE
- NO TITLE
- .
- Maintenance Safety
- Preparing for Maintenance
- Checking the Engine-Oil Level
- Checking and Adjusting the Skids and Scraper
- Checking and Adjusting the Traction Cable
- Checking and Adjusting the Auger/Impeller Cable
- Checking the Auger-Gearbox-Oil Level
- Changing the Engine Oil
- Lubricating the Hex Shaft
- Replacing the Spark Plug
- Adjusting the Discharge-Chute Latch
- Replacing the Drive Belts
- Replacing the Headlight Bulb
- NO TITLE
- NO TITLE
Setup
InstallingtheUpperHandle
g220055
Note:Donotremovetherubberbandonthecables
untilyouhaveinstalledtheupperhandle.
Installingthe
Wheel-Clutch-CableEnds
1.Unwrapanddiscardthebubblewrapfromthe
cablesonthelowerhandle(Figure5).
g001302
Figure5
2.Routeeithertheleftorrightcableendoverthe
lowerhandleandinsertthecableendintothe
holeinthecorrespondingwheel-clutchlever
(Figure6).
g001303
Figure6
1.Wheel-clutchlever
3.Removethenutandwasherfromthehandle,
attachthecableclamponthecabletothe
handle,installthewasherandthenut,and
tightenthenutbyhand(Figure7).
g001304
Figure7
1.Cableclamp(2)
5