Service Manual
Table Of Contents
- Revision History
- Preface
- Chapter 1 : Safety
- Chapter 2 : Specifications and Maintenance
- Chapter 3 : Troubleshooting
- Chapter 4 : Engine
- Chapter 5 : Track Drive System
- Chapter 6 : Controls
- Chapter 7 : Belts
- Chapter 8 : Auger Housing
- Chapter 9 : Auger Gearbox
- Chapter 10 : Discharge Chute
- Appendix A: Foldout Drawings
- Electrical Schematic with Hand Warmers
- Electrical Schematic
HydroInstallation(continued)
g332814
Figure30
12.Installtherearcovertotractionframeandsecurewith4(1/4–20x5/8inch)
bolts.
13.Installthetractioncabletotheundersideofthecontrolpanelandsecurewith
a(1/4–20x5/8inch)screw.Torquethescrewto6N•m(50in-lb).
Note:Oncethespeedcontrolcablehasbeenremoved,itmayneedtobe
re-settogainneutralpositionofthehydrobyadjustingthejamnuts.
14.InstalltheLHclutchcabletotheLHclutchlever.RepeatontheRHside
ofthemachine.
g332812
Figure31
15.Installthe3(1/4–20x5/8inch)screwssecuringtheheightadjusterassembly
andpivotbartotheframe.
TrackDriveSystem:ServiceandRepairs
Page5–16
POWERTRX™HDServiceManual
3440-740RevA