Service Manual

ManualsBrandsToro ManualsSnowthrowersPower TRX Commercial 1432 OHXE Snowthrower

Table Of Contents

Revision History
Preface
- Service Procedure Icons
Chapter 1 : Safety
- Safety Instructions
  - Think Safety First
Chapter 2 : Specifications and Maintenance
- Specifications
- Torque Specifications
  - Equivalents and Conversions
  - U.S. to Metric Conversions
Chapter 3 : Troubleshooting
- General Troubleshooting
Chapter 4 : Engine
- General Information
- Service and Repairs
  - Engine Replacement
Chapter 5 : Track Drive System
- General Information
- Service and Repairs
  - Track Replacement
  - Hydro Replacement
Chapter 6 : Controls
- General Information
- Service and Repairs
Chapter 7 : Belts
- General Information
- Service and Repairs
  - Auger Belt Replacement
  - Traction Belt Replacement
Chapter 8 : Auger Housing
- General Information
- Service and Repairs
  - Fixed Scraper
  - Scraper Replacement
Chapter 9 : Auger Gearbox
- General Information
- Service and Repairs
  - Auger and Traction Assemblies
  - Auger Gear Box Replacement
Chapter 10 : Discharge Chute
- General Information
- Service and Repairs
  - Chute and Face Gear Cover Replacement
  - Chute Gear Replacement
Appendix A: Foldout Drawings
- Electrical Drawing Abbreviations
Electrical Schematic with Hand Warmers
Electrical Schematic

QUICKSTICK®Disassembly(continued)

g262320

Figure43

QUICKSTICK®Reassembly

1.Placethelatchspringovertheboss.Thestraightendofthespringshouldbe

downwiththehookedendfacingup.

g262321

Figure44

2.Slidethelatchtriggeroverthebossuntilitisfullyseated,makingsurethat

thestoponthetriggerleverisabovethestoponthequicklever.While

holdingthetriggerleverinplace,rotatethehookedendofthespringuntil

ithooksunderthefrontedgeofthetriggerlever.

3.Rotatethecableuntilthebarrelttingslidesontothecablelever.

4.Installthelatchtriggerandspring.Liftthemetallatchpawlontothecable

leverhex.

5.Installthetophandleintoposition,securewith5Phillipsheadscrews.

6.Installthe(13/4inch)frictionwasher.Slidethechutecontrolrodintoplace.

Securewitha(9/16inch)locknutontotheshoulderbolt.

7.Installbothglobes.Securewith2Phillipsheadscrewsontherighthandside

ofthechutecontrolcover(thepartthatlookslikeaball).

8.Installthecapandscrewretainingthebluelevercap.

POWERTRX™HDServiceManual

Page6–9

Controls:ServiceandRepairs

3440-740RevA