Service Manual
Table Of Contents
- Revision History
- Preface
- Chapter 1 : Safety
- Chapter 2 : Specifications and Maintenance
- Chapter 3 : Troubleshooting
- Chapter 4 : Engine
- Chapter 5 : Track Drive System
- Chapter 6 : Controls
- Chapter 7 : Belts
- Chapter 8 : Auger Housing
- Chapter 9 : Auger Gearbox
- Chapter 10 : Discharge Chute
- Appendix A: Foldout Drawings
- Electrical Schematic with Hand Warmers
- Electrical Schematic
QUICKSTICK®Installation
Note:Thecableclampmustbeinstalledonthechutecontrolrodorthe
cablelatchwillnotfunction.
1.InstalltheQUICKSTICK®ontothecontrolpanel.Securewith3(1/4–20x1
inch)carriageboltsandnutsonthechutecontrolrod.
2.Installthefrontcoverintoposition.Securewiththelatchtabsontherear.
3.Installthe2(1/4–10x0.82inch)screwssecuringtheQUICKSTICK®cover
inplaceontheundersideofthecontrolpanel.
4.HooktheZ-bendandconnectthedeectorcablefromtheunderside.
ControlInterlockReplacement
ControlInterlockRemoval
1.Parkthemachineonalevelsurface.Stoptheengine,waitforallmoving
partstostopandremovethekey.
2.Disconnecttheaugerandtractioncablesfromthelevers.Ifthisisawheel
clutchmodel,disconnectthewheelclutchcables.
g263048
Figure45
3.RemovetheshoulderscrewundertheRHhandgrip.Whenremoved,the
lockoutlatch,extensionspring,atwasher,andlocknutwilldropout.
Controls:ServiceandRepairs
Page6–10
POWERTRX™HDServiceManual
3440-740RevA