Service Manual
Table Of Contents
- Revision History
- Preface
- Chapter 1 : Safety
- Chapter 2 : Specifications and Maintenance
- Chapter 3 : Troubleshooting
- Chapter 4 : Engine
- Chapter 5 : Track Drive System
- Chapter 6 : Controls
- Chapter 7 : Belts
- Chapter 8 : Auger Housing
- Chapter 9 : Auger Gearbox
- Chapter 10 : Discharge Chute
- Appendix A: Foldout Drawings
- Electrical Schematic with Hand Warmers
- Electrical Schematic
ChuteandFaceGearCoverReplacement
ChuteandFaceGearCoverRemoval
1.Parkthemachineonalevelsurface.Stoptheengine,waitforallmoving
partstostopandremovethekey.
2.Removethe(1/4–20x5/8inch)boltsecuringthecabletotheclampand
deectorlink.Removethecablefromtheclampanddeectorlink.
g263135
Figure74
3.RemovethePhillipsheadscrewretainingthegearcover.Liftthefrontof
thecoverandslidetowardstherear.
g263348
Figure75
4.Removethe(5/16–18x21/2inch)boltonthechutegear.
5.Removethechute.
ChuteandFaceGearCoverInstallation
1.Installthechute.Securewitha(5/16–18x21/2inch)boltonthefacegear.
DischargeChute:ServiceandRepairs
Page10–4
POWERTRX™HDServiceManual
3440-740RevA