MSDS

RELEASED Ver-F ©Toro 2019
Safety Data Sheet
TORO 5W-30 SNOWTHROWER OIL
Revision Date:
5/26/15
SECTION 5
Flash Point:
Flammable limits:
Extinguishing media:
Special firefighting procedures:
Unusual fire & explosion
hazards:
Byproducts of combustion:
Autoignition temperature:
Explosion data:
Other:
SECTION 6
Spill control procedures (land):
Spill control procedures
(water):
Waste disposal method:
Other:
SECTION 7
Handling procedures:
Storage procedures:
HANDLING AND STORAGE
Use dry chemical, alcohol foam, all purpose AFFF or carbon dioxide to extinguish fire.
DO NOT direct a solid stream of water or foam into hot, burning pools of liquid since this
may cause frothing and increase fire intensity. Frothing can be violent and possibly
endanger any firefighter standing too close to the burning liquid. Use water spray to cool
fire exposed containers and structures until fire is out if it can be done with minimal risk.
Avoid spreading burning material with water used for cooling purposes. Wear full
firefighting turn-out gear (full Bunker gear), and respiratory protection (SCBA).
Not determined. Care should always be exercised in dust/mist areas.
FIRE FIGHTING MEASURES
ACCIDENTAL RELEASE MEASURES
>200°C by Cleveland Open Cup Tester.
Not determined.
Not determined.
Fires involving this product may release oxides of carbon, phosphorus, nitrogen and
sulfur; reactive hydrocarbons and irritating vapors.
Dense smoke may be generated while burning. Toxic fumes, gases or vapors may
evolve on burning. High temperatures may create heavy flammable vapors that may
settle along ground level and low spots to create an invisible fire hazard.
Dispose of fire debris and contaminated extinguishing water in accordance with official
regulations.
Immediately turn off or isolate any source of ignition (pilot lights, electrical equipment,
flames, heaters, etc.). Evacuate area and ventilate. Personnel wearing proper
protective equipment should contain spill immediately with inert materials (sand, earth,
chemical spill pads of cotton) by forming dikes. Dikes should be placed to contain spill in
a manner that will prevent material from entering sewers and waterways. Large spill,
once contained, may be picked up using explosion proof, non-sparking vacuum pumps,
shovels, or buckets, and disposed of in suitable containers for disposal. If a large spill
occurs notify appropriate authorities. In case of road spill or accident contact Chem-Trec
(800-424-9300).
Try to contain large spills with floating booms to prevent spill from spreading. Remove
from surface by skimming or with suitable adsorbents. If a large spill occurs notify
appropriate authorities (normally the National Response Center or Coast Guard at 800-
424-8802).
Do not empty into drains. All disposals must comply with federal, state, and local
regulations. The material, if spilled or discarded may be a regulated waste. Refer to
state and local regulations. Department of Transportation (DOT) regulations may apply
for transporting this material when spilled. See Section 14.
CAUTION - If spilled material is cleaned up using a regulated solvent, the resulting waste
mixture will be regulated.
Keep containers closed when not in use. Do not transfer to unmarked containers.
Empty containers retain product residue which may exhibit hazards of material, therefore
do not pressurize, cut, glaze, weld, or use for any other purposes. Return drums to
reclamation centers for proper cleaning and reuse.
Handling temperatures should not exceed 60°C (140°F) to min imize danger of burns.
Open containers carefully in a well ventilated area or use appropriate respiratory
protection. Wash thoroughly after handling.
Store containers away from heat, sparks, open flame, or oxidizing materials. Extended
storage at excessive temperatures may produce odorous and toxic fumes from product
decomposition.
Page 2 of 6