FORMATTING, 92-0343 MODEL & UP PARTS LIST SET-UP AND DIGITAL SPEEDOMETER KIT J FOR USE ON THE MULTI-PRO 1100 & 5200 VEHICLES The Operator Instructions furnished with the SPEED-O-METER in this Kit are the generalized instructions for the installation of the SPEED-O-METER. The paper parts bag included with this kit provides the extra parts necessary to-install-the SPEED-O-Meter on-the MULTI PRO Vehicles.
MOUNTING THE MAGNETIC SENSOR: The magnet clip (in parts bag) has been modified for use on the Vehicle. See FIG. 3. ® Place the magnet against the stop at the end of the clip {longest dimension of magnet should be turned in the direction of turning wheel. ® Attach the magnet to the clip using epoxy or similar high quality adhesive. Use a cable tie to further secure the magnet. to.the.clip.and help prevent the magnet from being dislodged by field debris.
FORM NO. 92-0343 REF PART NO. DESCRIPTION QY 1 HHS, Lock Washer, 1/4% 3 3 22-11-JD Hex Nut, 1/4* NC recreant 3 4 95672 Cable newsreaders revs AR 5 82-01320 Speed Sensor Mounting 1 6 92-0122 Magnet . revue 1 7 $2-0121 Magnet Clip...v..oos 1 8 20-64-AD HHS, 7/16 NC x 374" 1 2 Lock Washer, 7/16* 22~14~AJD Hex Nut, 7/16 NC “ 1. i1 $92-0118 Speed Sensor Cable w/ Sensor & Connector. 1 12 22~13~AJRD Hex Mut, 3/8 NC e 2 13 92-0118 Rubber Washer .. ceases -2 14 ORDER MODEL NO.
FOR USE ON THE MULTI-PRO 1100 VEHICLE MOUNTING THE DISPLAY CONSOLE: = Remove the mounting bracket from the console by unscrewing knobs at each side. Set the rubber washers and knobs aside. ® Mount the bracket in the two holes provided in the console, using two 174" bolts, and lock washers as shown in PIG B ® Tut rubber washers back in place on console. Insert console into bracket g0 that bracket ends are outside the rubber washers. Screw in knobs and adjust to angle desired.
MOUNTING THE MAGNETIC SENSOR: The magnet clip (in parts bag) has’ been modified for use on the MULTI-PRO Vehicle. See FIG. 3. . ® Place the magnet against the stop at the end of the clip (longest dimension of magnet should be turned in the direction of turning wheel). W attach the magnet to the c¢lip, using epoxy or similar high duality adhesive.
