Installation Instructions
1
FORM NO. 99-0552 REV. B
SET-UP AND
PARTS LIST
SKID SPRAYER
Refer to the illustrated Parts List for the details of parts used in assembling the SKID SPRAYER.
©The TORO Company - 2000
All Rights Reserved
3. Apply thread sealer and install the 90° barbed
elbow into the bottom of the Tank. See FIG. 2.
NOTE: Position the barbed elbow as shown, so
that it will angle toward the muffler on the Skid
Sprayer engine after the Tank is installed on the
Skid Frame.
Note: Right and Left as used in the
following instructions, refer to the operators
right and left when seated in the normal
operating position.
Remove the Sprayer Skid from its shipping skid.
For ease of handling, while connecting the Hoses
to the Tank, disconnect the 1" x 53" Suction Hose
and the 1/2" x 45" Agitator Hose at their respective
Quick Couplers. See FIG. 1.
FIG. 1
1. Suction Hose 2. Agitator Hose
Quick Coupler Quick Coupler
TANK ASSEMBLY:
1. Cut the shipping straps and remove the
Spray Tank and Saddle Assembly from the ship-
ping skid.
2. Remove the two screws holding the Heat
Shield to the Tank Saddle and discard the Heat
Shield.
NOTE: In the following instructions, "thread
sealer" refers to Teflon thread tape.
FIG. 2
1. Barbed Elbow 3. Elbow & Quick
(Suction Line) Coupler (Overflow)
2. Spill-way 4. Mounting Member
4. Apply thread sealer and assemble the 90° St.
elbow to the male Quick Coupler. Install the elbow
into the fitting at the spill-way end of the Tank, so
that it angles toward the outside of the Tank as
shown in FIG. 2.
NOTE: If the Skid Sprayer is to be installed on
a Trailer, (as shown in FIG. 4), install the Elbow
and Quick Coupler in the Tank as shown in Detail
A of FIG. 2. If the Skid Sprayer is to be installed
on a Transport Vehicle (as shown in FIG. 5),
install the Elbow and Quick Coupler as shown
in Detail B of FIG. 2.
5. Loosen the hose clamp on the Suction Hose
and use it to secure the Hose to the barbed elbow
in the bottom of the Tank.
MODEL NO. 41411-90101 & UP
MODEL NO. 41020-90101 & UP
MODEL NO. 41120-90101 & UP
MODEL NO. 41021-90101 & UP