Addendum

Printed in the USA

 2003 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

Boom Kit

for Multi-Pro 1200, 1250, and 5600 Sprayers

Model No. 41027

Form No. 3329-758

Addendum

Note: This addendum includes a section to be performed

prior to the Installing the Extension Booms section of the

Boom Kit Installation.

Greasing the Pivot Arms

The boom pivot arms are not greased at the time of factory

assembly and must be greased before use.

Grease Type: No. 2 General Purpose Lithium Base Grease.

7. Manually place grease on the support shaft and within

the ball seat of the hinge plate as shown in Figure 1.

8. Grease the fitting located below the spring until grease

can be seen coming out of the bottom of the pivot

assembly (Fig. 1).

9. Repeat the procedure for opposite pivot arm.

Figure 1

Left pivot arm shown

1. Upper shaft

2. Ball seat of hinge plate

3. Grease fitting

4. Pivot assembly