FORM NO. 42897 SET-UPLAND MODEL NO. 41030 PARTS LIST ELECTRIC BOOMLIFTKIT J Refer to the illustrated Parts List for the details of parts used in assembling the Electric Boom Lift Kit. *Left" as used -in the following instructions, refer to the operator’s right and left when seated in the normal operating position. Likewise, “Front® and “Rear” as seen from the operator’s position.
RIGHT SWITCH {viewed from bottom of switch) wiring diagram Part Ho. 42203 WIRE HARNESS YO YELLOW WIRE 1N ACTUATOR PLUG RIGHT ACTUATOR 70 RED WIRE 1N ACTUATOR PLUG SWITCH LEFT Switch (Viewed from borzoi of switch) ® Run the Wire Harness along the left side of the Vehicle's Main Frame. m Pull the red and black wires {circled in the diagram above) from the split conduit. W Determine the point at which these wires are best positioned to bs connected to the Fuse Block, inside the Seat Support.
ELECTRIC BOON LIFT KIT REF. PART NO. DESCRIPTION QTY 1 28~28-D Hair Pin Cotter, 1/8 x 1" (f/w Boom Frame. 4 2 42195 Clevis Pin, 1/2 x 2 (f/w Boom 4 3 42833 Actuator Assembly « 2 4 30954 Switchover, 30955 Rubber Boot.. res “ 2 & 87-0610 Penumbrae 42203 Wire Harness 42765 30-amp 42875 #10 Insulated Spade . 1 * 41276 1/4" Female Push-On . 1 * 95672 Plastic . 4 * Indicates Parts furnished, but not shown.
2833 ACTUATOR REF PART NO DESCRIPTION QrY 1 42844 Cover Tube ..reverence .o 1 2 42848 Drive Screw Assembly . 1 3 42850 Front Housing . 1 4 42847 Clutch Assembly 42845 Rear Housing 42849 Moor e euthanasia . 1 7 42852 Motor Pinion Gear. . 1 8 42846 Intermediate Gear.
