Installation Instructions

3
f. Remove the five screws and lift the Spray Con-
trol Panel to expose the bottom side.
g. From within the Seat Base compartment,
route the Connector Housings through the two
holes in the Right Hand Inner Fender Panel and
up into the Console area.
h. Connect the Connector Housings to their re-
spective switches in the Spray Control Panel
(Green & Yellow to L.H. Switch & Blue & White to
R.H. Switch).
i. Reinstall the Spray Control Panel to the Seat
Base and secure with the five screws removed
earlier.
REAR
FIG. 7
1745
3
1
2
FIG. 6
1. Connector Housing 3. Tang
2. Locking Arm
1
2
3
1743
FIG. 8
1722
1. Actuator Wire Harness
2. Vehicle Wire Harness
3. Spade Terminal
4. Ground Terminal Block
5. Push-On Terminal
6. Fuse Block
7. Main Fuse (30Amp)
8. Actuator Fuse (30Amp)
1. Plug 3. Spray Control Panel
2. Notch (at back)
to which the locking Arm will mate.
e. Lift and remove the two plugs from the
Vehicle's Spray Control panel and install the two
Rocker Switches provided in their place. Ensure
their orientation matches the orientation shown
in FIG. 7, with the cutout notch to the rear of the
vehicle. This notch indicates the end of the switch