Installation Instructions

4
3. FOR MULTI PRO
®
5600 ONLY. Wiring Har-
ness is already in place. Plug yellow and green
connector into right actuator and orange and
blue connector into left actuator. Continue with
number 8, this page.
4. Ground the spade terminal on the black wire
to the Terminal Block. See FIG. 9, page 4.
5. Connect the push-on terminal on the red wire
to the male terminal on the red wire coming from
the Fuse Block. See FIG. 8, page 3.
6. Make a trial connection by plugging single
terminals into the Actuator plug, to check the up
and down motion and the right and left control.
7. If all connections are correct, use the plastic
Connector for final connection.
1721
WIRING DIAGRAM - FIG. 9
For the Multi Pro® 1100 & 5500
3. Run the wiring Harness along the left side of
the Vehicle's Main Frame (On Multi Pro
®
5500,
route through Wire Harness rings along right
side of Vehicle Main Frame, and replace
Switch Panel Assembly onto Center Console.
NOTE: Apply silicone at joint and on the back
side of Plug where wires enter the plug.
8. Secure the Wire Harness to the Boom and
Vehicle Frame with plastic cable ties.
IMPORTANT: Cover or otherwise protect the
Electric Actuators when using a high pressure
hose washer. Water entering the Actuator will
cause SERIOUS DAMAGE and premature fail-
ure of the unit!