Operator's Manual

20
STORAGE
SPRAYING SYSTEM
1. Flush pump and entire spraying system with
water and tank cleaning agent. Drain pump and
spray system completely.
2. Add a rust inhibiting antifreeze solution to the
pump and recirculate through the system, coating
the pump interior. Drain solution completely.
3. Remove Flow Meter at the end of each spraying
season. Clean Flow Meter turbine and inlet hub.
Clean off all metal fillings and wettable powders
which have hardened on the plastic and metal
parts. Check the inlet hub and turbine assembly
for worn or damaged turbine blades and bearings.
Flush Flow Meter with clear water and drain.
FREEZING TEMPERATURES MAY DAMAGE
FLOW METER IF WATER IS NOT DRAINED.
4. Remove console from Sprayer Vehicle when
not in use for extended periods of time.
6. Lubricate boom pivot grease fittings and pivot
points.
IMPORTANT! WHEN A HIGH PRESSURE
WASHER OR GARDEN HOSE IS USED FOR
CLEANING, IT IS NECESSARY TO COVER AND
PROTECT THE CONTROL CONSOLE. WATER
ENTERING THE CONTROL CONSOLE WILL
CAUSE SERIOUS DAMAGE TO THE
ELECTRONICS.
Remove the Control Console from the vehicle for
storage, or otherwise protect it from the elements.
If repairs are ever needed or assistance is required,
contact an Authorized TORO Distributor.
SERVICING AFTER STORAGE: Flush the entire
Spraying System with clean water and detergent.
Rinse and drain the entire Spraying System.
STORAGE AND DISPOSAL OF CHEMICALS:
Follow Chemical Manufacturer's
recommendations for storage and disposal of
chemicals.
5. Check condition of spray hoses. Tighten all
hose connections securely.
NOTES: