Setup Instructions

1
FORM NO. 106-1226
This manual includes set-up instructions for areas that are specific to the MULTI PRO
®
5600. Refer to
the complete Set-Up instructions and its illustrated Parts List for the details of parts used in assembling
the Sonic Boom
 Kit.
©The TORO Company - 2002
All Rights Reserved
NOTE: In order to use a Sonic Boom Kit your
sprayer must first be equipped with an Electric
Boom Lift Kit. The Harness included with the
Electric Boom Lift Kit will not be used with the
Sonic Boom accessory and may be
discarded.
MODEL NO. 41089
SONIC BOOM KIT - MULTI PRO
®
5600
SET-UP
INSTRUCTIONS
SHEET
NOTE: "Right" and "Left: as used in the
following instructions, refer to the operator's
right and left when seated in the normal
operating position. Likewise "Front" and
"Rear" as seen from the operator's position.
2. Mount four (4) Relays to Plate using 1/4 NC x
5/8" hex hd cap screws, lock washers and hex
nuts.
3. Mount Fuse Block to Plate using two (2) # 10
NCx5/8" rec. rd. hd. mach. screws and hex nuts.
4. Connect Wiring Harness to ECU and Relays.
Tighten ECU and Connector screws.
FIG.1
1726
1. ECU
2. Plate
3. 4 Relays
4. Fuse Block
5. Wiring Harness
6. Mounting Post
5. Mount ECU plate to Vehicle post on right side
under Dash, using two (2) 5/16 NC x 3/4" cap
screws and lock washers. See FIG. 2.
1. Mount ECU to Plate using four (4) 1/4 NC x
2-1/2" hex hd cap screws, lock washers and hex
nuts. See FIG. 1.
7. Route Wiring Harness through floor along
side the Vehicle Harness and Hydraulic Lines.
Route under floor toward the right side of the
vehicle, through harness guides, and to front right
corner of the Seat Box.
8. Install "R" Clamps provided in place of existing
"R" Clamps located under both Passenger and
Operator Seats.
6. Install Sonic Boom Decal and Indicator Light
on Dash, and connect Harness Leads to Light.
See FIG. 2.
1. Indicator Light 2. Sonic Boom Decal
FIG. 2
1727