Service Bulletin

Customer Service Bulletin

Commercial Business Group

Multi Pro

Hose Reel or Spray Gun Kits

Date: March 20, 2003

Units Affected: Model Numbers

Serial Numbers

41134 220000101 - 230000164

41133 220000101 - 230000200

Subject: Hose Reel or Spray Gun Difficult to Adjust.

SITUATION: Note: This information pertains to all Hose Reel or Spray Gun Kits

that use this Ball Valve (104-9069) now and in the future. The

situation described has only been found on very few units within the

listed range. Improperly positioned Ball Valve handles will cause a

lack of adjustability with the hose reel. The result of the handle being

positioned improperly is high system pressures that cannot be

lowered and excessive vibration due to system going over relief

constantly.

CORRECTION: Verify the handle of the Ball Valve controlling the Hose Reel or Spray

Gun Kits is positioned correctly. When positioned correctly the arrow

on the handle always points to the largest opening in the Ball. To

verify the handle is correctly positioned:

• Turn the handle counterclockwise until it contacts the stop.

• Verify that the arrow is pointing toward the rear of the vehicle.

• Remove the rear hose from the Ball Valve and verify that the

largest hole in the Ball is facing the rear of the machine. (Refer to

figures 1 and 2)

If the handle is positioned incorrectly in reference to the large hole,

remove the handle and reposition correctly.

Figure 1

Figure 2

Rear hose removed – large hole should be visible

With Arrow pointing to the