Operator's Manual
4. R emo v e the lync h pins and clevis pins securing
the pi v ot brac k ets to the frame c hannels
( Figure 4 )
Figure 4
1. Left rear corner of bed 4. Clevis pin
2. Vehicle frame channel 5. Lynch pin
3. Pivot plate
T he full bed w eighs appr o ximatel y 210
pounds, so do not tr y to install or r emo v e
it by y our self. Get the help of tw o or thr ee
other people or use an o v erhead crane.
5. Lift the bed off the v ehicle .
6. Store the cylinders in storag e clips . Eng ag e
the h y draulic lift loc k lev er on the v ehicle
to prev ent accidental extension of the lift
cylinders .
Step
2
Preparing the Workman ®
No Parts Required
Procedure
1. P ark the v ehicle in a safe w ork space with
access to a lift.
2. T ur n the engine off and remo v e the k ey .
3. Disconnect the neg ati v e batter y cable from the
post.
Note: T his is a safety precaution since the
installation will require installing an electrical
har ness .
Step
3
Installing the Vehicle Speed
Sensor
Parts needed for this step:
1
Cover assembly
1
Gear tooth assembly
1
Screw (M6 x 1 inch x 12)
1
Spring washer (M6)
Procedure
Important: T he speed sensor must be
installed prior to the installation of the
P o w er T ak e Of f (PT O) kit. If a PT O kit w as
pr eviousl y installed it must be r emo v ed at this
time. See the PT O kit Installation Instr uctions
f or mor e inf or mation on r emo ving and
installing the PT O kit.
1. R emo v e the four bolts securing the co v er to
the top of the transaxle housing ( Figure 5 ).
R emo v e the m uffler brac k et.
Figure 5
1. Cover
3. Transaxle housing
2. Bolt 4. Mufer bracket
2. Apply R TV sealant to the new co v er assembly
before installing it onto the transaxle unit.
14