Operator's Manual

Step
5
Installing the Control Box
Mount
Parts needed for this step:
1
Adapter bracket
4
Bolt (1/4 x 3/4 inch)
4
Flange nut (1/4 inch)
1
Control box mount
4
Bolt (5/16 x 1 inch)
4
Lock nut (5/16 inch)
Procedure
On some v ehicles the control mount plate is
attac hed to the dashboard at the same point the
hand throttle assembly is mounted. If the hand
throttle kit is installed it m ust be se parated from
the dashboard in order to install the control mount
plate . R efer to the Hand T hrottle Kit Operator’ s
Manual for directions in remo ving and installing
the hand throttle assembly .
Install the control bo x mount to the W orkman
dashboard (or adapter plate) using three bolts
(5/16 x 1 inc h) and three loc k n uts (5/16 inc h)
as sho wn in Figure 10 .
Note: Some older W orkman mac hines ma y use
four bolts and loc k n uts .
Figure 10
1. Control box mount
3. Bolt (5/16 x 1 inch)
2. Dashboard
4. Lock nut (5/16 inch)
Installing the Adapter Plate
If y ou are installing the spra y system on a W orkman
v ehicle with a serial n umber of 239999999 or
lo w er , y ou will need to use the adapter plate , bolts ,
and n uts included in the loose par ts .
Install the adapter plate to the W orkman dashboard
using four bolts (1/4 x 3/4 inc h) and four flang e
n uts (1/4 inc h) as sho wn in Figure 11
Figure 11
1. Adapter plate 4. Control mount
2. Bolt (1/4 x 3/4 inch) 5. Bolt (5/16 x 1 inch)
3. Flange nut (1/4 inch) 6. Lock nut (5/16 inch)
Step
6
Installing the Prop Rod
Assembly
Parts needed for this step:
1
Support bracket assembly
2
Socket head bolts (3/8 x 1 inch)
2
Lock nut (3/8 inch)
1
Prop rod assembly
1
Clevis pin
1
Cotter pin
Procedure
1. R emo v e the left rear tire and wheel assembly .
R etain all par ts .
2. Install the str ut suppor t assembly to the inside
of the left frame rail using tw o soc k et head
bolts (3/8 x 1 inc h) and tw o loc k n uts (3/8
17