Operator's Manual

inc h) as sho wn in Figure 12 and Figure 13 .

T or que the n uts to 30 ± 3 ft-lb (30 ± 4 N ⋅ m).

Figure 12

Inside view

1. Strut support assembly

3. Socket head bolt (3/8 x 1

inch)

2. Left frame rail

4. Lock nut (3/8 inch)

3. Install the left rear wheel and tire assembly .

Figure 13

Outside view, shown without fender.

1. Strut support assembly

3. Socket head bolt (3/8 x 1

inch)

2. Left frame rail

4. If necessar y , loosely assemble the prop rod,

jam n ut, and y ok e (Fig . 13).

5. Install the prop rod assembly on the inside of

the rear , lefthand side of the tank skid frame

at the y ok e using a clevis pin and cotter pin

( Figure 14 ).

Figure 14

1. Prop rod 4. Clevis pin

2. Jam nut 5. Cotter

3. Yoke

6. Bend the cotter pin to secure the prop rod into

place .

Step

Installing the Attachment

Hold-down Brackets

Parts needed for this step:

Hold-down brackets

Procedure

1. Locate and remo v e the tw o rear bolts and

ﬂang e n uts on the lift cylinder brac k et. R etain

the fasteners for later use .

2. Install the attac hment hold-do wn brac k ets

using the tw o bolts and ﬂang e n uts remo v ed

previously ( Figure 15 ).