Operator's Manual

1. Using a lift, raise the tank skid assembly and

position o v er the v ehicle frame with the pump

and v alv e assemblies facing rearw ard.

2. T ur n the prop rod 90° and guide it through the

prop rod suppor t ( Figure 17 ) as the tank skid

is slo wly lo w ered.

Figure 17

1. Tank skid assembly 3. Prop rod support assembly

2. Prop rod, turned 90°

3. Once the prop rod is through the suppor t

assembly , tur n the prop rod 90° to retain it

within the suppor t and contin ue to lo w er the

tank skid assembly to the v ehicle frame .

4. Use the access panels on both sides of the

tank skid to c hec k for pinc hing of any hoses

or wiring ( Figure 18 ).

Figure 18

Right side shown

1. Access panel door 2. Interior of the tank skid

Important: If an y hoses or wiring on

the tank skid assembl y ar e being pinched

or bent, raise the assembl y up , adjust its

positioning , and tie items back.

5. Line up the pi v ot lug at the rear of the tank

skid assembly with the opening at the end of

the v ehicle frame ( Figure 19 ).

Figure 19

Left side shown

1. Pivot lug 3. Lynch pin

2. Clevis pin (3/4 inch)

4. Vehicle frame

6. Install a clevis pin (3/4 inc h) and tw o lync h

pins to the pi v ot lug to secure the tank

assembly to frame ( Figure 19 ).

7. R e peat on the opposite side .

8. Attac h the pump dri v e:

Figure 20

1. Rubber cowling 3. PTO output shaft

2. PTO drive shaft

• Pull rearw ard on the r ubber co wling of the

front of the PTO dri v e shaft ( Figure 20 ).

• Install the dri v e shaft onto the PTO output

shaft ( Figure 20 ).