Operator's Manual

sho wn in Figure 26 with 4 bolts (1/2 x 1-1/4
inc hes) and four loc k n uts (1/2 inc h).
Note: If necessar y , the boom frame mounts
can be loosened and adjusted at the center
boom assembly for better hole alignment.
Figure 26
4. Connect the boom actuators wires to the
cor responding connectors on the spra y system
har ness .
5. P o w er on the system and use the boom lift
switc hes to extend the boom actuator rods .
T his is to allo w the left and right boom
extensions to be installed.
6. R emo v e the four bolts , four w ashers and four
n uts on the hing e plate .
7. Install the extension boom to the center boom
at the hing e plate using four bolts , four w ashers
and four n uts remo v ed in ste p 6 as sho wn in
Figure 27 .
Note: Ensure all spra y tur rets are facing to
the rear .
Figure 27
1. Center boom assembly 4. Bolt
2. Boom extension
5. Washer
3. Hinge plate
6. Nut
8. R e peat ste p 7 on the other side of the center
boom assembly with the opposing boom
extension.
Note: Ensure all spra y tur rets are facing to
the rear .
23