Operator's Manual

ManualsBrandsToro ManualsAttachmentsWorkman 200 Spray System, Heavy-Duty Workman Vehicles

Boom Lift Switches

T he electric boom lift switc hes raise and lo w er

their respecti v e booms ( Figure 30 ). T here is a left

and right lift switc h. Press and hold the switc h

upw ard to raise the respecti v e boom, or press and

hold the switc h do wnw ard to lo w er the respecti v e

boom.

Sonic Boom and Foam Marker Switch

Locations (Optional)

If y ou install the sonic boom and/or the foam

mark er kit, y ou will add switc hes to the control

panel for controlling their operation. T he spra yer

comes with plastic plugs in these locations .

Rate Control Valve

T his v alv e , located behind the tank ( Figure 31 ),

controls the amount of ﬂuid that is routed to the

booms b y directing ﬂuid ﬂo w to the booms or the

b ypass hose to the agitation v alv e . Y ou can control

this v alv e in tw o w a ys: the application rate switc h

or man ually . T o control it man ually , y ou need to

disconnect the wire connector on the v alv e , then

y ou can rotate the knob on top of the v alv e to

man ually obtain the desired application rate .

Figure 31

1. Rate control valve 3. Boom valves

2. Flowmeter

Flowmeter

T he ﬂo wmeter measures the ﬂo w rate of the ﬂuid

for use b y the Spra y Pro ™ system ( Figure 31 ).

Boom Valves

T hese v alv es tur n the three booms on or off

( Figure 31 ). If y ou do not ha v e a boom installed

or do not w ant a boom to be able to be tur ned

on, y ou can man ually operate eac h v alv e b y

disconnecting the wire connector in the v alv e , then

rotate the knob on the v alv e cloc kwise to tur n the

v alv e off or countercloc kwise to tur n it on.

Boom Bypass Valves

T he boom b ypass v alv es redirect the ﬂuid ﬂo w for

a boom to the tank when y ou tur n off the boom

section. Y ou can adjust these v alv es to ensure that

the boom pressure remains constant no matter

ho w many booms are on. R efer to Calibrating the

Boom Bypass V alv es , in the Operation section.

Agitation Control Valve

T his v alv e is located on the right side of the tank

( Figure 32 ). T ur n the knob on the v alv e to the

9 o’cloc k position to tur n on the tank agitation

and to the 3 o’cloc k position to tur n off the tank

agitation.

Figure 32

1. Agitation control valve

2. Pressure gauge

Note: F or agitation to w ork, the PTO and clutc h

m ust be eng ag ed, and the engine m ust be r unning

abo v e an idle . If y ou stop the spra yer and need

agitation on, place the rang e shift lev er in the

Neutral position, let out the clutc h, set the parking

brak e , and set the hand throttle (if equipped).

Pressure Gauge

T he pressure g aug e is located to the right of the

tank ( Figure 32 ). T his g aug e sho ws the pressure of

the ﬂuid in the system in psi and bar .