Operator's Manual

Lubrication
Greasing the Sprayer System
Lubricate all bearings and bushings after ev er y
100 hours or once a year , whic hev er occurs first.
Grease T ype: No . 2 General Pur pose Lithium
Base Grease
1. Wipe the g rease fitting clean so that foreign
matter cannot be forced into the bearing or
bushing .
2. Pump g rease into the bearing or bushing .
Important: Onl y a few pumps of g r ease
ar e r equir ed to lubricate the system. Do
not o v er g r ease. Gr ease will not purge fr om
the system.
Figure 42
1. Pump
3. Pressure Dampener
2. Grease tting
Greasing the Boom Hinges
Important: If the boom hinge is w ashed
with w ater , all w ater and de bris must be
clear ed fr om the hinge assembl y and fr esh
g r ease must be applied.
Grease T ype: No . 2 g eneral-pur pose lithium base
g rease .
1. Wipe the g rease fittings clean so that foreign
matter cannot be forced into the bearing or
bushing .
2. Pump g rease into the bearing or bushing at
eac h fitting Figure 43 .
Figure 43
Right boom
1. Grease tting
3. Wipe off ex cess g rease .
4. R e peat the procedure for eac h boom pi v ot.
Greasing the Actuator Rod
Bearings
Grease the bearing end of the both boom actuator
rods at 400 hours and/or yearly .
Grease T ype: No . 2 g eneral-pur pose lithium base
g rease .
1. Extend the booms to the spra y position.
43