Operator's Manual

10.Checkthealignmentofthetankskidandthevehicle
frame.Ifnecessary,loosentheboltssecuringthepivot
lugtothetankskidframeslightly(Figure21).Raisethe
tankassemblyjustenoughabovethevehicleframeto
bealignedandloweredintoproperposition.Tighten
theboltsonthepivotlugoncethetankskidisaligned
withthevehicleframe.
11.Usetheaccesspanelsonbothsidesofthetankskidto
checkforpinchingofanyhosesorwiring(Figure22).
Figure22
Rightsideshown
1.Accesspaneldoor
2.Interiorofthetankskid
Important:Ifanyhosesorwiringonthetank
skidassemblyarebeingpinchedorbent,raisethe
assemblyup,adjustitspositioning,andtieitems
back.
12.Repeatontheoppositeside.
13.Attachthepumpdrive:
Figure23
1.Rubbercowling
3.PTOoutputshaft
2.PTOdriveshaft
•Pullrearwardontherubbercowlingofthefrontof
thePTOdriveshaft(Figure23).
•InstallthedriveshaftontothePTOoutputshaft
(
Figure23).
Important:VerifythePTOshaftissecuredby
makingsurethelockingballsareseatedinthe
grooveoftheoutputshaft.
14.Lineupthefrontmountingbracketswiththehold
downbracketsinstalledpreviously.
15.Securethetankskidassemblytotheframewithabolt
(1/2x1-1/2inches),twowashers(1/2inch),anda
locknut(1/2inch)asshowninFigure24.
Figure24
Leftsideshown
1.Frontmountingbracket
4.Washer(1/2inch)
2.Hold-downbracket
5.Locknut(1/2inch)
3.Bolt(1/2x1-1/2inches)
16.Repeatthesestepsforthefrontmountingbracketand
hold-downbracketontheoppositeside.
10
InstallingtheControlBox
Partsneededforthisprocedure:
1Knob
3J-clips
1
Bolt(1/4x3/4inch)
1
Flangenut(1/4inch)
1
SprayProdecal,US
1
SprayProdecal,CE
Procedure
Thecontrolboxismountedonthetankskidbyaclevispin,
andhairpin.Itislocatedontheleftsidetowardtheback.
1.Removetheclevispin,andhairpinsecuringthecontrol
boxtothetankskid.
2.Installthecontrolbox,withthecontrolsfacingthe
driver,tothecontrolmountusingtheclevispinand
hairpinremovedpreviously.
3.Installthehandknobtostabilizethecontrolbox.
Tightenbyhand.
20