Installation Instructions

ManualsBrandsToro ManualsAttachmentsSpreader Base Unit, 2002 and After Workman 3000/4000 and HD Series Utility Vehicle

Printed in the USA

 2002 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

Spreader Base Unit

For 2002 and prior Workman 3000 and 4000D Series

Model No. 41253

Form No. 3327–628

Installation Instructions

Safety and Instruction Decals

Safety decals and instructions are easily visible to the operator and are located near any area

of potential danger. Replace any decal that is damaged or lost.

93-9084

1. Lift point 2. Tie-down point

93-9356

1. Entanglement hazard, belt—stay away from moving parts.

93-9863

1. Tipping hazard—read the

Operator’s Manual.

2. Waring—maximum load

is 318 kg.

93-6689

1. Warning—do not carry passengers.

93-6687

1. Do not step here.

94-1236

1. Crushing hazard—stay clear of the articulation area while the

engine is running.

2. Thrown object hazard—keep bystanders a safe distance from

the machine.

65-3090

93-7814

1. Entanglement hazard, belt—stay away from moving parts.

93-9528

Summary of content (4 pages)

PAGE 1
Form No. 3327–628 Spreader Base Unit For 2002 and prior Workman 3000 and 4000D Series Model No. 41253 Installation Instructions Safety and Instruction Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or lost. 93-9084 1. Lift point 93-6687 2. Tie-down point 1. Do not step here. 93-9356 1. Entanglement hazard, belt—stay away from moving parts. 94-1236 1.
PAGE 2
Note: Install the High Flow Hydraulic Control Kit to the Workman before installing spreader base. Refer to installation instructions included with kit. 5. Mount access cover to spreader frame with (4) washer head screws (Fig. 1). 6. Mount (2) straight fittings and O–rings to motor (Fig. 1). 1. Remove all components from packaging. Remove and retain attachment mounting brackets and fasteners used to secure spreader frame to packaging skid. 7.
PAGE 3
11. With bed lowered, remove clevis pins and lynch pins securing each cylinder rod end to bed mounting plates (Fig. 2). 3 2 1 1 Figure 4 4 1. Engine frame mounting bracket 2. Vehicle frame 3 2 16. Mount spreader drive to support channel with (2) M12 x 65mm capscrews, (2) M12 x 40mm capscrews and (4) M12 nuts (Fig. 5). Hardware provided with spreader. Figure 2 1. Bed mounting plate 2. Cylinder rod end 3. Attachment mounting bracket 3. Clevis pin 4. Lynch pin 12.
PAGE 4
18. Loosely mount rear support tubes to spreader frame with (3) flange bolts and (1) flange nut (Fig. 5). 25. Mount support channel and spreader to spreader frame with (4) bolts and washers (Fig. 5). Washers to be positioned between channel and frame. 19. Loosely mount upper frame to support tubes with (4) flange bolts and flange nuts (Fig. 5). Note: When mounting spreader, slide pump side of PTO shaft onto pump while mounting spreader. 20.