FORM NO. 100-7095 MODEL NO. 41358 OPERATORS, SET-UP AND PARTS MANUAL ENCLOSED WALKING BOOM SERIAL NO. 200000141 & UP To assure maximum safety, optimum performance, and to gain knowledge of the product, it is essential that you or any other operator of this equipment read and understand the contents of this manual before the product is used. Pay particular attention to the SAFETY INSTRUCTIONS highlighted by the triangular safety alert symbol.
FOREWORD You have purchased a product from the industry leader in maintenance excellence. Its future performance and dependability are of prime importance. TORO is also concerned about future use of the product and of safety to the user. Therefore, this manual must be read by you and those involved with the ENCLOSED WALKING BOOM to assure that safety, proper set-up, operation and maintenance procedures are followed at all times. The major sections of the manual are: 1. SAFETY INSTRUCTIONS 2.
SAFETY DECAL & SERIAL PLATE Part No. 100-7093 Located on Center Section Shroud, left of flow indicator.
10 5 9 11 6 3 4 13 12 7 8 2 FIG. 1. 1. Upper Handle Section 2. Lower Handle Section 3. Large Wheel 4. Magnet 5. Small wheel 6. Boom Extension Frame 7. Main Boom Feed Hose 8. Speedometer 9. Boom Extension Shroud 10. Retainer Knob 11. Shroud Lockup Pin 12. Drift Seal Retainer 13.
SET-UP INSTRUCTIONS NOTE: Right, Left, Front and Rear are referenced while standing in the operators position. BOOM FRAME ASSEMBLY left flow indicator, etc.). Secure with Hose Clamps. Secure hosed to Frame with tie straps ensuring that the hose does not interfere with the spray pattern or the movement of the Boom Extension. 1. Assemble the Upper Handle Section onto the Lower Handle Section using the (2) # 10 x 3/4 sheet metal screws to secure. 2.
BEFORE SPRAYING IMPORTANT: The Enclosed Boom nozzle bar is fixed at 15" height and 20 inch spacing. Use only Flat Fan 1100 tips to maintain proper calibration. EXAMPLE (SI FORMULA) Application Rate = 907 L/hectare Vehicle Speed = 5 km/h Nozzle Spacing = 50 cm NOZZLE SELECTION 907 L/ha x 5 km/h x 50 60,000 See the SPRAY NOZZLE SELECTION CHART to be sure that your spray nozzles have the capacity necessary to achieve the application rate selected. With 3.78 G.P.M.
SPRAY NOZZLE SELECTION CHART 7252 1R]]OH 3UHVVXUH &DSDFLW\ 3DUW 1R 1XPEHU 36,* 1R]]OH 03+ 03+ 03+ %URZQ
OPERATING INSTRUCTIONS FLOW MONITOR SPEEDOMETER PROGRAMMING 1. The Flow Monitor has four sight tubes, each tube contains a weighted ball that floats when there is a flow to the corresponding nozzle. 1. The Wheel Size Input Variable for the Walking Boom Sprayer is 0800. If for any reason the Variable has been changed or erased use the following steps to reprogram the Speedometer. Removing and/or replacing the battery will erase settings. 2.
Wheel Variable Size Input: To input Walking Boom Wheel Variable (0800) press right button to advance digits as needed and left button to select and advance. The Display units and the Wheel variable can be changed in the SPD/ODO screen mode. Odometer (ODO) - Press left bottom to advance digits to previous mileage reading. Press right button to select and advance to next digit. After final selection, speedometer will exit Setup Mode and enter SPD/CLK Screen Mode.
MAIN GROUP 47 46
FLOW INDICATOR GROUP 48 49 50 52 56 51 57 53 53 54 50 50 58 55 50 53 53
MAIN GROUP 5HI 3DUW 1R 'HVFULSWLRQ &HQWHU 6HFWLRQ $VVHPEO\ ,QFOXGLQJ 4W\ 5HI 3DUW 1R )UDPH &HQWHU 6HFWLRQ -RLQW 6HDO 'ULIW 6HDO 5HWDLQHU &HQWHU [ 3DQ KG VHOI WDSSLQJ SKLOLSV 6HFWLRQ )URQW XVHG ZLWK VHDO QRW VKRZQ 5HG 9LQ\O ,QVHUW &HQWHU 6HFWLRQ )URQW 'ULIW 6HDO &HQWHU 6HFWLRQ )URQW +H[ KG FDS VFUHZ 1& [ 6KUR
PLUMBING GROUP FLOW INDICATOR GROUP 4W\ 5HI 3DUW 1R +RVH &RQQHFWRU )*+7 [ +% )ORZ ,QGLFDWRU $VVHPEO\ $GDSWHU )LWWLQJ )37 0*+7 256 +RVH 6KDQN 9DOYH 2 5LQJ &DS 3OXJ %DOO 5HWDLQHU 037 +% )ORZ ,QGLFDWRU %DOO 6WHHO 037 +% /RFN 8 &OLS
2 1 6 7 8 3 4 5 NOZZLE ASSEMBLY - Detailed Parts Breakdown 5HI 3DUW 1R 'HVFULSWLRQ 1R]]OHERG\ 7ULSOH 7\SH $VV\ ,QFOXGHV 4W\ 1R]]OHERG\ RI 'LDSKUDJP RI 'LDSKUDJP &DS S V L RI 1R]]OHERG\ 0RXQWLQJ +DUGZDUH SDLUV *DVNHW 1R]]OH 6SUD\ 1R]]OH 7HHMHW ;5 66 6SUD\ 1R]]OH 7HHMHW ;5 66 6SUD\ 1R]]OH 7HHMHW ;5 96 6SUD\ 1R]]OH 7HHMHW ;5 96 6SUD\ 1R]]OH 7HHMHW ;5
DRIFT SEAL RETAINER, DRIFT SEAL AND TRIM GROUP 5HI 3DUW 1R 'HVFULSWLRQ 'ULIW 6HDO 5HWDLQHU &HQWHU 6HFWLRQ 4W\ )URQW 5HDU 'ULIW 6HDO 5HWDLQHU %RRP 'ULIW 6HDO &HQWHU 6HFWLRQ )URQW 'ULIW 6HDO &HQWHU 6HFWLRQ 5HDU 'HVFULSWLRQ 4W\ 'ULIW 6HDO %RRP ([WHQVLRQ 5HG 9LQ\O ,QVHUW &HQWHU 6HFWLRQ )URQW 5HDU 5HG 9LQ\O ,QVHUW %RRP
The Toro Promise A One Year Limited Warranty The Toro Company promises to repair your Model 41358 ENCLOSED WALKING BOOM if defective in materials or workmanship. The following time periods from the date of purchase apply special warranty terms, on certain components, may be offered through The Toro Company by the component manufacturers: Commercial Products...........................1 Year The cost of parts, labor and transportation are included.
