Form No. 3354-867 Rev A Enclosed Walking Boom Trailer For Enclosed Walking Boom Model No. 41359—Serial No. 260000001 and Up Register your product at www.Toro.
Introduction Read this manual carefully to learn how to operate and maintain your product properly. The information in this manual can help you and others avoid injury and product damage. Although Toro designs and produces safe products, you are responsible for operating the product properly and safely.
Safety F. Always adjust the vehicle speed to allow for existing conditions such as wet or slick surfaces, low visibility, etc. Before Operating G. Be especially careful when driving a heavily loaded vehicle down an incline or slope. Drive the vehicle UP and DOWN the face of the slopes, inclines or grades whenever possible. DO NOT DRIVE across the face if at all possible. There is a risk of upsetting the vehicle, which can result in serious injury or death. 1.
Setup Loose Parts Use the chart below to verify that all parts have been shipped. Step 1 2 3 Qty.
Step 1. Install the universal tow hitch to the center boom using 2 U-bolts and 4 lock nuts (3/8 inch) as shown in (Figure 3). 1 Mounting the Universal Tow Hitch Parts needed for this step: 1 1 2 4 4 Universal tow hitch Mounting plate U-bolt Bolt (3/8 x 1 inch) Locknut (3/8 inch) Procedure Figure 3 For all machines with serial numbers 260000001 and up: 1. 2. 3. 1.
Step bolt is installed into the wheel mount side with the larger hole so the fastener head recesses when tightened and contacts the main frame assembly. 3 Connecting the Trailer to the Tow Hitch Parts needed for this step: 1 2 2 1 1 Tow hitch bar Bolt (3/8 x 2 inches) Lock nut (3/8 inch) Hitch pin Hair pin Procedure If the tow hitch is less then 14 inches off the ground the lower holes in the main frame assembly should be used.
Figure 5 1. 2. 3. 4. 5. Main frame assembly Upper holes Lower holes Tow hitch bar Bolt (3/8 x 2 inches) 6. 7. 8. 9. Lock nut (3/8 inch) Universal tow hitch Hitch pin Hair pin 3. Align the trailer tow hitch bar tabs with the universal tow hitch tongue between them (Figure 5). 4. Insert the hitch pin through the tabs and tow hitch tongue and secure it with a hair pin (Figure 5).
Operation General Maintenance Loading the Enclosed Walking Boom onto the Trailer Grease the wheel bearings of the trailer with No. 2 general purpose lithium base grease. 1. Ensure that the walking boom extensions are locked in the transport position. 2. Move the walking boom into position directly behind the trailer and insert the front wheel into the holder on the trailer main frame. 3.
