FORM NO. 95-2190 OPERATOR'S MODEL NO. 41565 INSTRUCTIONS HOSE REEL KIT J for the Multi-Pro® 5500 The safety alert symbol means CAUTION, WARNING or DANGER--personal safety instruction. Failure to comply with the instruction may result in personal injury, To assure maximum safety, optimum performance, and to ?ain knowledge of the product, it is essential that you or any other operator of this equipment read and understand the contents of this manual before the vehicle engine is ever started.
SAFETY INSTRUCTIONS 5. Make certain everyone is clear of the machine and work site before starting the engine and beginning to spray. WHILE OPERATING: 6. Do not direct spray at any persons or pets; even low pressure is very dangerous and can cause serious injury. 7. Equipment begins to vibrate abnormally, stop Immediately. Shut off the vehicle engine and disengages all power. Repair all damage before commencing operation. 8. Keep hands clear of chain/sprockst drive system. 9.
CONTROLS AND OPERATION HOSE REEL SWITCH (FIG. 1): Activates the hose reel motor which spins the hose reel. HOSE REEL VALVE HANDLE (FIG. 1): Opens and closes hose reel valve to open or shut off the supply of spray liquid to the hose real, 1001 002 FiG. 1 1. Hose Reel Switch 2. Hose Reel Valve Handle OPERATION: WINDING HOSE ONTO REEL: NOTE: Be aware that the reel switch is an ON/ OFF switch and does NOT control the speed of the winding action.
SERVICE MAINTENANCE: CHAIN TENSION: A caution TO PREVENT PERSONAL INJURY, REMOVE ALL ELECTRICAL POWER FROM MOTOR BEFORE ADJUSTING CHAIN TENSION. DISCONNECT THE BATTERY WIRE FROM THE VEHICLE BATTERY'S POSITIVE POST TO REMOVE ELECTRICAL POWER. IMPORTANT! Over-pensioning (tightening) of chain results in reduced motor rife. Adjust the chain to allow between pray In chain. 1. Loosen (do not remove) the (4) bolts which g%d :the motor mounting bracket to the reel. See 2.
SERVICE 3. Remove the {4) #10 x 1/2" screws, washers, and nuts that secure the cover plate on the electric box assembly. 4. Disconnect the positive wire of the reel motor from the terminal on the circuit breaker located on the cover plate assembly. Pull the wire out through the opening found in the bottom of the electric box. 5. Remove the (4) 5/16"x 1/2" hex hd cap screws and nuts securing motor mounting bracket and motor to hos reel. Remove bracket and motor See FIG. 3. 6.
The Toto Commercial Products Two Year Limited Warranty The Tore Company warrants your 1996 or newer Toto Commercial Product {"Product”) purchased after January 1, 1997, to be free from defects In materials or workmanship for the period of time Listed below. Where a unwarrantable condition exists, Tore will repair the Product at no cost 10 you Including diagnosis, labor , parts, and transportation. This warranty begins on the date the Product is delivered to the original retell purchaser.