Operator's Manual

OPERATORS
INSTRUCTIONS
CAB
for the MULTI-PRO
®
5500 Vehicle
FORM NO. 95-2411 REV. A
©The TORO Company - 2001
All Rights Reserved
To assure maximum safety, optimum
performance, and to gain knowledge of the
product, it is essential that you or any other
operator of this Vehicle read and understand the
contents of this manual before the engine is ever
started. Pay particular attention to the SAFETY
INSTRUCTIONS highlighted by the triangular
safety alert symbol.
The safety alert symbol means CAUTION,
WARNING or DANGER - personal safety
instruction. Failure to comply with the
instruction may result in personal injury.
Keep this Operators Manual in the plastic tube behind the operator seat.
It is very important that all persons operating this equipment have easy access to these instructions at all
times!
Carefully read and follow the Installation Instructions that are provided with this equipment and the Safety
Instructions in the Multi-Pro
TM
Operators Manual.
SAFETY INSTRUCTIONS
RECOGNIZE SAFETY INFORMATION
This safety-alert symbol is used to call
attention to a dangerous situation, which
could result in serious injury or death to the operator
or a bystander.
Safety, mechanical and some general information
in this manual are emphasized. DANGER,
WARNING and CAUTION identify safety
messages. Whenever the triangular safety symbol
appears, it is followed by a safety message that
must be read and understood. For more details
concerning safety, read the Safety Instructions on
this page and page 2. IMPORTANT identifies
special mechanical information and NOTE identifies
general information worthy of special attention.
These instructions are provided as a guide for the
safe operation and maintenance of this equipment.
However, the operators personal safety, as well as
those persons in the work area, will depend on the
careful actions and good judgement of the operator.
To reduce the potential for injury or death,
comply with the following safety instructions.
BEFORE OPERATING:
1. Operate this machine only after reading and
understanding the contents of this manual. A
replacement manual is available by sending
complete model and serial number to: Hahn
Equipment Co., a subsidiary of The Toro Company,
1625 N. Garvin, Evansville, IN 47711.
2. Learn how to use the controls properly. DO
NOT let anyone operate this equipment without first
receiving thorough instructions.
3. Keep all shields, safety devices and decals in
place. If a shield, safety device or decal is
malfunctioning, illegible or damaged, repair or
replace it before operating the machine.
4. It is mandatory to wear the seat belt at all times
when operating the machine equipped with the
Cab system. (Always adjust and secure Seat Belt
before operating the machine.)
5. Wear Face Mask.
6. Chemicals can injure persons, animals, plants,
soils or other property. To eliminate environmental
damage and personal injury:
A. Follow manufacturer's instructions on
chemical container labels. Apply and handle
chemicals as recommended.
B. Handle and apply chemicals with care.
Wear goggles and other necessary protective
equipment. Handle chemicals in well ventilated
areas. Never smoke while handling chemicals.
C. Properly dispose of chemical container and
unused chemicals.
7. Make certain everyone is clear of the machine
and work site before starting the engine and
beginning to spray.
Model No. 41567

Summary of content (8 pages)