Installation Instructions

InstallingtheRinseNozzles
Ownerprovidedmaterial:PTFEsealant
1.Workinginsidethetankthroughthe41cm(16
inch)opening,alignthenozzleassemblyup
throughthe4.5cm(1-3/4inch)holethatyou
drilledinDrillingtheSprayT ank(page9)as
showninFigure21.
g206558
Figure21
1.Hole—4.5cm(1-3/4
inch)—rear
3.Rinse-nozzleassembly
2.Plasticangenut
2.Assembletheplasticangenutoverthethreads
ofthebulkheadttingattopofthetank,and
tightentheangenutbyhand(Figure21).
3.Attheforward4.5cm(1-3/4inch)holeinthe
spraytank,repeatsteps1through2forthe
otherrinse-nozzleassembly(Figure22).
g206557
Figure22
1.Plasticangenut
3.Rinse-nozzleassembly
2.Hole4.5cm(1-3/4
inch)—forward
4.ApplyPTFEthreadsealanttothethreadsofthe
both90°ttings.
5.Installthe90°ttingsintothebulkheadttingsof
therinse-nozzleassemblies(Figure23).
g206567
Figure23
1.90°tting3.Bulkheadtting
(rinse-nozzleassembly)
2.Rightsideofthemachine
6.Alignthehosebarbofthe90°ttingstotheright
sideofthemachine(Figure23).
7.Installthelterbasketandclosethelidofthe
spraytank.
11