Installation Instructions

ManualsBrandsToro ManualsAttachmentsManual Spray Mode Kit, Multi-Pro 5800 Turf Sprayer

FormNo.3366-692RevC

ManualSprayModeKit

Multi-Pro

5800TurfSprayer

ModelNo.41616

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Balancingvalve1

90-degreeelbow1

O-ring

Flynut1

Hosebarbteetting

Straightbarbedtting

Ballvalve1

Hoseclamp6

Agitationbypasshose1

Installthekit.

Nopartsrequired

–

Calibratethebalancingvalveassembly.

InstallingtheKit

1.Parkthemachineonalevelsurface,settheparking

brake,shutofftheengine,andremovethekey.

2.Removethe3quickpinsthatholdthe3plugsonthe

boommanifoldvalvesinplace(Figure1).

Figure1

1.Quickpin(3)2.Plug(3)

3.Installthebalancingvalveassemblyasshownin

Figure2,andsecureitwiththe3quickpinsthatyou

removedinstep2.

Figure2

1.Quickpins

2.Balancingvalve

4.InstalltheO-ringontheangedendofthe90-degree

elbow ,andinserttheelbowintotheright-handside

ofthebalancingvalveassembly(Figure3).

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

Summary of content (4 pages)

PAGE 1
Form No. 3366-692 Rev C Manual Spray Mode Kit Multi-Pro® 5800 Turf Sprayer Model No. 41616 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. Balancing valve 90-degree elbow O-ring Fly nut Hosebarb tee fitting Straight barbed fitting Ball valve Hose clamp Agitation bypass hose 1 1 1 1 1 2 1 6 1 Install the kit. No parts required – Calibrate the balancing valve assembly. Installing the Kit 1.
PAGE 2
Figure 3 1. 2. 3. 4. 5. 6. Balancing valve assembly O-ring Fly nut 90-degree elbow Hose clamp (6) Straight barbed fitting (2) 7. 8. 9. 10. 11. Ball valve Agitation bypass hose Hosebarb tee fitting Drain hose Drain valve 12. Insert the ball valve and 2 straight barbed fittings and 2 hose clamps as shown in Figure 3. 5. Slip a fly nut over the 90-degree elbow and secure the elbow by screwing on the fly nut over the elbow until it is hand tight. 13.
PAGE 3
Note: Before using the sprayer for the first time or if the nozzles are changed, adjust the balancing valve assembly so that the pressure and application rate remains the same for all booms when you turn one or more booms off. 1. Select an open flat area to perform this procedure. 2. Fill the spray tank with clean water. 3. Put the extension booms down, if they are installed. 4. Set the parking brake and start the engine. 5. Move the throttle lever to the Spray position. 6.
PAGE 4