Operator's Manual

Primer

Press in the primer three times before starting a cold

engine (Fig. 14).

Figure 14

1. Engine primer 2. Fuel shut–off valve

Fuel Shut–Off Valve

The fuel shut–off valve is located on the left side of the

engine. Close the valve to stop the fuel flow from the fuel

tank and open the valve to allow the fuel to flow to the

carburetor (Fig. 14). Close the valve when transporting the

line painter or when it is not in use.

Recoil Starter

The recoil starter (Fig. 15) is on the top of the engine. Pull

the recoil starter to start the engine.

Figure 15

1. Recoil starter

Flush/Paint Lever

Rotate the flush/paint lever up to flush the system. Rotate

the lever down to paint. Center position is Off (Fig. 13)

The Off position closes all flow to the pump. Use the Off

position when paint is in the tank and the paint filter has

to be serviced. Do not operate the engine when the

flush/paint lever is in the Off position

Flush

Paint

Off

Figure 16

1. Flush/Paint Knob

Starting the Engine

1. Make sure the spark plug wire is connected to the

spark plug (Fig. 17).

Figure 17

1. Spark plug wire

2. Engage the parking brake (Fig. 18).

3. Ensure that the speed selector lever is in Neutral and

the paint and traction control levers are in the

disengaged (released) position (Fig. 18)).

4. Open the fuel shut–off valve (Fig. 15).

5. Press the primer three times (Fig. 14).