Operator's Manual

Figure 20

1. Tank cover

5. Pour the desired amount of mixed paint, through the

strainer and into the tank. Do not remove the paint

strainer.

6. Install the tank cover.

Mixing Paint in the Tank

Certain brands of latex based paint can be mixed in the

paint tank.

1. Start the engine.

2. Move the Flush/Paint lever to the paint position.

3. Pour the desired amount of water into the tank. Use the

marks on the side of the tank to measure the amount.

4. Pour the desired amount of paint, through the strainer,

and into the tank.

5. Allow the machine to mix the paint for 1 minute

before painting.

Adjusting the Paint Width

1. Loosen the wing nuts securing the spray shields to the

the boom arm (Fig. 21).

Note: Use the slotted end of the filter wrench to assist in

loosening or tightening the wing nuts.

Figure 21

1. Spray shield

2. Spray shield wing nuts

3. Boom arm stop

2. Move the shields (Fig. 21) in or out until the desired

line width is attained. Make sure each shield is equal

distance from the spray nozzle.

3. Tighten the wing nuts.

4. Loosen the screw securing the paint nozzle tube to the

boom arm (Fig. 22).

Figure 22

1. Spray nozzle

2. Nozzle tube screw

3. Check valve

5. Raise or lower the nozzle tube until the paint sprays

slightly below the shields (Fig. 23).