Service Manual

Line Painter 1200Page 5 – 16Paint System

Flush (Water) Tank

Figure 11

1. Paint tank

2. Tank support

3. Cap

4. Cap insert

5. Gasket

6. Stud

7. Flush tank

8. Extension spring

9. Tank support rod

10. Spray pump assembly

11. Elbow fitting

12. Clamp

13. Bushing

14. Flange head screw (4 used)

FRONT

RIGHT

Removal (Fig. 11)

1. Drain paint tank (see Operator’s Manual).

NOTE: The nozzle can be removed from the spray

head to allow the flush tank to be emptied faster.

2. Operate line painter in the flush mode until the flush

tank is empty.

3. Park machine on a level surface, stop engine, en-

gage parking brake and remove key from the ignition

switch. Remove high tension lead from the spark plug

and position the lead away from the spark plug.

4. Tip tank support to gain access to flush tank (see

Tank Support in this section).

1. Flush tank

2. Extension spring

3. Tank support rod

Figure 12