Service Manual

Line Painter 1200Page 5 – 26Paint System
Spray Pump Drive Belt
1. Engine pulley
2. Lock nut
3. Idler pulley
4. Shoulder screw
5. Extension spring
6. Idler bracket
7. Pivot washer
8. Cap screw
9. Lock nut
10. Spray pump
11. Pump drive belt
12. Pump pulley
13. Set screw
14. Square key
15. Flat washer
16. Lock washer
17. Cap screw
Figure 29
2
3
4
1
5
6
7
8
10
11
12
9
13
14
15
16
17
Removal (Fig. 29)
1. Drain paint tank (see Operator’s Manual).
2. Park machine on a level surface, stop engine, en-
gage parking brake and remove key from the ignition
switch. Remove high tension lead from the spark plug
and position the lead away from the spark plug.
3. Under chassis, rotate idler bracket and pulley to re-
lease tension on pump drive belt. While holding idler
pulley away from pump drive belt, remove belt from
pump pulley. Carefully release idler bracket and pulley.
4. Remove pump drive belt from engine pulley and ma-
chine.
Installation (Fig. 29)
1. Position pump drive belt to engine pulley.
2. Rotate idler bracket and pulley to allow belt to be
installed on pump pulley. Carefully release idler bracket
and pulley to tension belt.
3. Secure high tension lead to spark plug.