Service Manual

Adjustments

Traction Drive Cable

1. Park machine on a level surface, stop engine, en-

gage parking brake and remove key from the ignition

switch.

Remove high tension lead from the spark plug

and position the lead away from the spark plug.

2. Make sure that traction lever on handle is released.

3. Adjust location of traction cable jam nuts so that trac-

tion cable spring is stretched .120” to .250” (3.0 to 6.4

mm) from it’

s relaxed state.

4. Make sure that jam nuts are fully tightened and that

boot is positioned on end of traction cable.

5. Secure high tension lead to spark plug.

Figure 1

1. Traction drive cable 4. Cable spring

2. Idler bracket 5. Cable

boot

3. Jam nut

Line Painter 1200 Page 6 – 3 Chassis and Controls

Chassis and

Controls