Service Manual

2. Connect brake cable to brake lever on handle (Fig. 4. Secure high tension lead to spark plug.
6):
A. Slide cable end onto brake lever and secure with
hair pin.
B. Secure cable to handle assembly with jam nut.
3. Connect brake cable to brake lever on transaxle (Fig.
7):
A. Connect cable spring to brake lever.
B. Position cable to chassis bracket.
C. Tighten cable jam nuts enough to prevent cable
spring hook from coming of
f transaxle brake lever.
When properly adjusted, the cable spring should not
be stretched.
Figure 7
1
2
3
1. Brake cable spring 3. Cable jam nut
D. Make sure that cable boot is positioned over end
2. Brake lever
of cable.
Line Painter 1200 Page 6 – 9 Chassis and Controls
Chassis and
Controls