Service Manual

Installation (Fig. 13)

1. Position paint control cable to machine.

2. Connect paint control cable to paint control lever

machine handle:

A. Slide cable end onto paint control lever and se-

cure with hair pin.

B. Secure cable to handle assembly with jam nut.

C. Make sure that cable boot is positioned over end

of cable.

3. Connect paint control cable to paint shutoff valve

(Figs. 14):

A. Secure cable clevis to shutof

f valve lever with cle-

vis pin and hair pin.

B. Position shutoff valve lever to shutoff valve and

Figure 14

secure with two (2) cotterless pins.

1. Paint control cable 3. Paint shutoff valve

2. Paint shutoff valve lever 4. Cable

boot

C. Position cable to chassis bracket.

D. Tighten cable jam nuts to allow slight cable free -

play. Verify that operator control lever has

E. Make sure that cable boot is positioned over end

of cable.

4. After cable installation, verify that operator paint con-

trol lever has from .050” to .100” (1.3 to 2.5 mm) freeplay

Readjust cable if necessary.

5. Secure high tension lead to spark plug.

Figure 15

1. Pivot cotterless pin 2. Spool cotterless pin

Chassis and

Controls

Line Painter 1200 Page 6 – 15 Chassis and Controls