Service Manual

Installation (Fig. 16)
1. If removed, install bushing(s) (item 9) into chassis.
2. If removed, install castor plate to castor fork with two
(2) socket head screws (item 3) and lock washers (item
4).
3. Coat stem of castor fork with grease. Slide fork into
chassis.
4. Position wave washer (item 1
1) and rebound washer
(item 12) to top of castor fork. Secure castor fork to ma-
chine with flange head screw (item 13).
5. Install castor wheel to castor fork (see Wheel Instal-
lation in this section).
6. Carefully lower machine to ground.
7. Lubricate grease fitting for castor fork.
8. Secure high tension lead to spark plug.
9. Release castor release lever on handle to engage
castor detent.
10.Operate machine to make sure it follows a straight
line. I
f machine does not track correctly, adjust front cas-
tor fork (see Front Castor Fork in the Adjustments sec-
tion).
Line Painter 1200 Page 6 – 17 Chassis and Controls
Chassis and
Controls