Operator's Manual

13
Important Using Mobil DTE 26 or equivalent ISO VG
68 hydraulic oil when temperature at start–up is less than
40_F (4.5_C) could cause serious hydraulic system
damage.
1. Position the sweeper on a level surface and make sure
engine is off.
2. Remove dipstick cap (located under operators seat)
from filler neck and wipe it with a clean rag. Insert
dipstick cap onto filler neck; then remove it and check
level of oil. If level is below the L mark on dipstick, add
sufficient hydraulic fluid to bring to the F mark. DO
NOT OVERFILL.
Important To prevent system contamination, clean top
of hydraulic oil containers before opening. Assure pour
spout and funnel are clean. When adding oil to the
hydraulic system, use a funnel with a fine screen–200
mesh–and ensure funnel and oil are clean. This procedure
prevents accidental contamination of the hydraulic oil
which will damage the hydraulic system.
1
Figure 3
1. Dipstick cap
Check Torque of Wheel Nuts
Failure to maintain proper torque could result in
failure or loss of wheel and could result In personal
Injury. Torque rear wheel lug nuts to 45–55 ft. lb.
Warning
1
Figure 4
1. Lug nut