Installation Instructions

3
12. Remove two flange head capscrews and flange locknuts
securing rear of each engine frame mounting bracket to
each side of vehicle frame (Fig. 7).
1
2
3
Figure 7
1. Engine frame mounting
bracket
2. Vehicle frame
3. Attachment bracket
13. Loosely secure a attachment bracket to each engine
frame mounting bracket and vehicle frame with two
flange head capscrews and flange locknuts previously
removed (Fig. 7).
14. Loosely secure top of each attachment bracket to tab on
each side of hitch frame with a 1/2 x 1-1/2 inch large
capscrews two flatwashers and locknuts (Fig. 7).
Tighten all fasteners.
15. Insert a 1/2 x 4 inch large capscrew and flatwasher thru
holes in each side of hitch assembly as shown in Figure
8. Partially thread a locknut onto end of capscrew. Do
not tighten. Capscrew heads to be positioned on inside
on both sides.
1
4
3
2
Figure 8
1. Hitch assembly
2. Capscrew
3. Flatwashers
4. Locknuts
16. Slide slots on bottom of draw bar assembly onto
capscrews as shown in Figure 9. Pivot draw bar
assembly upward and align top holes with holes in hitch
assembly. Secure draw bar assembly to hitch assembly
with two 1/2 x 4 inch large and locknuts. Tighten all
fasteners.
1
Figure 9
1. Draw bar
Note: Steps 17 & 18 are performed on 2/3 beds only.
17. Remove capscrews and locknuts securing spacer
brackets to front of R.H. and L.H. bed frame channels
(Fig. 10). Retain screws for later use.
2/3 Bed Only
1
Figure 10
1. Spacer bracket