FORM NO. 3318-412 GB Rev A MODEL NO. 44220—60001 & UP MODEL NO.
Foreword Thank you for buying a high-quality Toro turf care product. To get the best performance from this machine, operate and maintain it according to the instructions in this manual. Toro also wants to stress the importance of safety. You and anyone else using or maintaining this machine are strongly urged to read this manual, especially all the safety instructions. DANGER, WARNING and CAUTION, used with the triangular safety alert symbol, highlight safety messages.
Safety Instructions SAFETY INSTRUCTIONS The safety alert symbol means CAUTION, WARNING or DANGER -personal safety instruction". Read and understand the instruction because it has to do with safety. Failure to comply with the instruction may result in personal injury. BEFORE OPERATING 1. Read and understand all operating and safety instructions. Before operating this unit, become familiar with all controls and know how to stop quickly. 2.
F. Do not attempt sharp turns or abrupt maneuvers or other unsafe driving actions that may cause a loss of vehicle control. G. Before backing up, look to the rear and assure no one is behind. Back up slowly. H. Watch out for traffic when near or crossing roads. Always yield the right of way to pedestrians and other vehicles. This vehicle is not designed for use on streets or highways. Always signal your turns or stop early enough so other persons know what you plan to do.
Specifications Top Dressing Speed: Varies depending on desired application rate. Dimensions: Height: 28" (71 cm) Length: 50"(127 cm) Width: 68" (1 73 cm) Conveyor Belt: Continuous 1.52 m wide composition belt with heavy duty polyester cord. Hopper Metering Gate: Infinitely variable from closed to 3" (7.6 cm) opening for light to heavy applications.
Controls GATE CONTROL(Fig. 6) , The black knob on the left side of the unit, near the brush, is used to lock the gate into the desired open height position. 1. Loosen the black knob enough to allow it to pivot freely in the slot. 2. Set the gate into the desired position and tighten the black knob to lock into position. Figure 1 1. Black knob Operating Instructions 3. Move shift lever to NEUTRAL position and depress clutch lever. Rotating parts can grab or pinch.
scale. The maximum weight capacity of the rear axle of the Workman is 2600 pounds. 7. Transport to the area to be topdressed. 8. Open the gate arm to the desired rate. Lock into position with the black knob. 9. Move the shift lever into “LO” range position. Select the desired forward speed and begin moving. 10. Pull the Remote Hydraulic Lever back to the “RUN" position. The unit is now topdressing.
Maintenance LUBRICATION SEASONAL STORAGE BEARINGS (Fig. 2) 1. Thoroughly clean the topdresser especially inside the hopper. The hopper and conveyor belt area should be free of any remaining sand particles 2. Tighten all fasteners. IMPORTANT: Lubricate the bearings to maintain a slight leakage on the seals. Too much grease can cause overheating. 3. Lubricate all grease fittings and bearings. Wipe off excess lubricant. DRIVE CHAIN (Fig. 2) 4.