Operator's Manual

18
1
Figure 15
1. Bearing housing
2. Loosen nuts securing brush motor (Fig. 16) to left side
of machine.
1
Figure 16
1. Brush motor
3. Slide brush into position on right side. Finger tighten
nuts.
4. Slide brush into position on left side. Finger tighten
nuts.
5. Insert a piece of stiff paper between the brush and the
conveyor belt. The brush must be the same height
from side to side.
6. If the adjustment is correct, tighten nuts. If not, repeat
procedure.
Tensioning Drive Chains
The chains should be tensioned so they deflect 1/8”. Do
not over tighten, this will cause chain wear. Do not
operate with a loose chain, this will cause sprocket wear.
Conveyor Belt Chain
1. Remove chain cover (Fig. NO TAG).
1
Figure 17
1. Chain cover
2. Loosen bolts and nuts securing motor and sprocket
assembly to the main frame (Fig, 18).
3. Rotate motor and sprocket assembly, in mounting
slots, until proper tension is achieved.
1
2
Figure 18
1. Drive chain 2. Motor & sprocket
assembly
4. Tighten mounting bolts.
5. Install chain cover.