Operator's Manual

20
1
1
2
Figure 22
1. Hopper seal 2. Gate edge
1. Remove chain cover (Fig. 23).
1
Figure 23
1. Chain cover
2. Remove master link from chain and remove chain
from small sprocket (Fig. 24).
1
3
2
Figure 24
1. Drive chain
2. Master link
3. Motor
Note: Motor mounting bolts may have to be loosened to
disassemble chain link.
3. Loosen jam nuts and nuts on tension rod to release
spring tension (Fig. 25).
1
2
Figure 25
1. Tension rods 2. Nuts
4. Remove (2) capscrews, washers and nut, on each side
of machine, securing hopper to slider bed (Fig. 26).