Operator's Manual

Install Tongue

1. Install tongue into topdresser receiving tube and secure

each end with a clevis pin and (2) lynch pins

(Fig. 2 & 3).

Figure 2

1. Front of tongue 2. Tongue hitch

Figure 3

1. Rear tongue

Install Tongue Hitch

1. Level the tongue hitch to the tow vehicle drawbar and

secure using appropriate holes.

Mount Optional Tongue Jack

1. Slide tongue jack onto mounting tube on tongue.

Figure 4

1. Tongue jack

2. Align holes in jack with tongue and secure with clevis

pin.

3. For storage, jack can be removed or rotated upward

and pinned.

Install Wire Harness

1. Plug topdresser wire harness into connector on

topdresser solenoid valve.

100-7882

Figure 5

1. Topdresser harness

2. Controller harness

3. Tow vehicle harness

2. Secure appropriate terminals of tow vehicle harness to

tow vehicle battery (+ or –).

Important Make sure harness is connected to

correct terminals on battery.

3. Unplug loop back connectors from each harness and

plug harness’s together.

Note: To prevent dirt or corrosion to harness connector

pins, Install loop back connectors to connectors whenever

vehicle harness’s are disconnected.