Operator's Manual

13
CONTROLS
GATE METERING CONTROL
The knob and handle on left rear side of machine are
used to adjust and lock the gate into the desired open
height position.
1. Loosen the adjusting handle enough to allow knob
to slide freely in slot.
2. Set the gate into the desired position and tighten
the handle to lock into position.
RATE SCALE
Use rate scale to determine desired flow rate. Refer to
Sand Application Rate, page 16.
HAND CONTROL SWITCH
Activating hand control switch starts and stops the flow
of material from topdresser.
Figure 7
1. Gate adjusting knob & pointer
2. Locking handle
3. Rate scale
1
2
3