Operator's Manual

21
MAINTENANCE
Figure 22
1. Chain cover
1
2. Remove master link from chain and remove chain
from small sprocket (Fig. 23).
Figure 23
1. Drive chain
2. Master link
3. Motor
1
3
2
Note: Motor mounting bolts may have to be loosened to
disassemble chain link.
3. Loosen jam nuts and nuts on tension rod to release
spring tension (Fig. 24).
Figure 24
1. Tension rod
2. Nuts
1
2
4. Remove (2) capscrews, washers and nut, on each
side of machine, securing hopper to slider bed
(Fig. 25).
Figure 25
1.Hopper mounting capscrews
(Right side shown)
1
5. Pivot hopper rearward and lean against wall,
ladder, etc. Do no allow hopper to rest against rear of
machine as damage may result to brash or hydraulic
couplers (Fig. 26).
IMPORTANT: Make sure hopper is pivoted beyond
center and/or secured to wall or post to prevent it
from accidentally falling on work area (Fig. 26).
Figure 26
6. Loosen (2) capscrews, washers and nut, on right
side of machine, securing slider bed to frame (Fig. 27).
Make sure fasteners are loose enough to allow slider
bed to be tipped.
Figure 27
1. Slider bed mounting cap
screws
1
7. Remove (2) capscrews, washers and nut, on left
side of machine, securing slider bed to frame (Fig. 28).